Comtech EF Data LPOD Spécifications télécharger pdf (Page 38)

LPODnet M&C Netbook Accessory Revision 3

Ethernet-Based M&C using the LPODnet MN-LPODNET

3–8

3.5.1.2 Summary of Remote Control Commands and Queries

Table 3-1 on the next page summarizes the remote commands and queries available for the

SSPA. Full explanations of functionality are provided in Chapter 5. SERIAL-BASED REMOTE

PRODUCT MANAGEMENT in the pertinent SSPA manual (CEFD P/N MN-LPOD or MN-SPODPSX).

• Column ‘C’ = Command.

• Column ‘Q’ = Query.

• Columns marked ‘

X’ designate that instruction code as Command only, Query only, or

Command/Query.

• Where an Instruction Code is noted XXX

this denotes a command/query designated as

End-of-Life (EOL). While these commands are fully supported in this product it is highly

recommended that the equivalent new commands are used for new implementations.

• Where an Instruction Code is noted XXX

this denotes a command/query that is

available only when a reference oscillator is installed.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 59 60

Pas de commentaire

Comtech EF Data LPOD Spécifications Page 38