Comtech EF Data CDM-710G Spécifications Page 85

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 246
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 84
CDM-710G High-Speed Satellite Modem Revision 1
Front Panel Operation MN-CDM710G
6–9
If Interface Æ RS232 is selected:
In RS232 Mode the Bus
Address is fixed at 0000
If Interface Æ RS485 is selected, the user will be further prompted:
RS485 Mod Address: 0001
(E)
The valid range of addresses is from 1 to 9999. To edit the RS485 address of the modem, use the
W X arrow keys to select the digit to be edited, then use the ST arrow keys to change the value of
the digit. Press
ENTER when done.
If Serial CONFIG: Æ Baudrate is selected:
Local M&C Bus Baud Rate:
9600 Baud ( E )
Values of 1200, 2400, 4800, 9600, 19200, 38400, and 57600 baud are possible for the Baud rate
of the remote control bus connected locally to the M&C computer. Use the
ST arrow keys to
change the value, then press
ENTER.
Note: The Asynchronous character format is FIXED at 8 data bits, No parity, and 1 stop bit (8-N-1).
(CONFIG:) Remote Control Æ Ethernet
Ethernet CONFIG: Gateway
Address MAC SNMP ( E)
Select Gateway, Address, MAC, or SNMP using the W X arrow keys, then press ENTER.
If Ethernet CONFIG: Æ Gateway is selected:
Ethernet IP Gateway:
063.168.001.127 ( E )
Use the arrow keys to select the digit to be edited, then use the W X arrow keys to change the
value of the digit. Press
ENTER when done.
If Ethernet CONFIG: Æ Address is selected:
Ether IP Address/Range:
192.168.001.001/24 ()
The range is adjustable from 08 to 30. Use the W X arrow keys to select the digit to be edited, then
use the
ST arrow keys to change the value of the digit. Press ENTER when done.
Vue de la page 84
1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 245 246

Commentaires sur ces manuels

Pas de commentaire