Comtech EF Data CDM-710L Spécifications télécharger pdf (Page 29)

CRS-170A L-Band 1:1 Redundancy Switch MN/CRS170A.IOM

Introduction Revision 13

1–9

Figure 1-5. CDM-625/A, -850, -840, -760, -750, -710GL, -710, -700 1:1 IP Redundancy

Managed Switch Mode – Switchover

As shown in Figure 1-5, in the event of a fault on the Online unit ‘A’, the following will occur:

• Modem ‘A’ goes offline and disables its Ethernet data interface.

• Simultaneously, Modem ‘B’ goes online and enables its Ethernet data interface.

• Layer 2 Switch ‘A’ senses that Port 4 is no longer active and clears the CAM table entries for

that port.

• When the next Ethernet packet from Local PC ‘A’ destined for Remote PC ‘B’ arrives at

Switch ‘A’, there is no CAM entry for the PC ‘B’ MAC, so it will be broadcast to all active

ports.

• When the next Ethernet packet from Remote PC ‘B’ arrives at Switch ‘A’, Switch ‘A’

dynamically adds the PC ‘B’ MAC to the CAM table for Port 3.

Note the following:

1) The Managed Switch Mode method of redundancy is intended to be equivalent to pulling

the Ethernet cable from one port and putting it into a different port on the same switch.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 171 172

Pas de commentaire

Comtech EF Data CDM-710L Spécifications Page 29