Comtech EF Data CDM-600 Spécifications télécharger pdf (Page 31)

Chapter 2. INSTALLATION

2.1 Unpacking and Inspection

The CRS-170A L-Band 1:1 Redundancy Switch module and its Installation and Operation Manual

are packaged and shipped in a pre-formed, reusable cardboard carton containing foam spacing for

maximum shipping protection.

CAUTION

IMPORTANT

Do not use any cutting tool that will extend more than 1” into the container

and cause damage to the unit.

Be sure to keep all shipping materials for the carrier's inspection.

Unpack and inspect the CRS-170A as follows:

Step Procedure

1 Inspect shipping containers for damage.

If shipping containers are damaged, keep them until the contents of the

shipment have been carefully inspected and checked for normal

operation.

3 Remove the packing list from the outside of the shipping carton.

4 Open the carton and remove the contents.

Check the contents against the packing list to verify completeness of

the shipment.

If damage is evident, contact the carrier and Comtech EF Data

immediately and submit a damage report.

If the unit needs to be returned to Comtech EF Data, use the original

shipping container.

2–1

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 89 90

Pas de commentaire

Comtech EF Data CDM-600 Spécifications Page 31