Comtech EF Data Vipersat CDD-564L Spécifications Page 122
- Page / 172
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
CDD-562L/564 Demodulator with IP Module Revision 1
Appendix A MN/CDD564L.IOM
A–4
A.2.5 Restoring Factory Default Configuration
The remaining sections in this appendix assume that the CDM-IP is still in factory default
configuration for IP. If this is not the case, the factory default configuration may be restored from
the menu as follows:
Step Description
1 From the Main Menu, select the Operations and Maintenance submenu [O].
2 From the Operations and Maintenance submenu, select Database Operations submenu [D].
3 From the Database Operations menu, select Restore Factory Default option [R].
4
When the following prompt is displayed:
Are you sure you want to restore factory default settings?
WARNING: Choosing Yes will restore factory defaults and then reboot..
Confirm restore, when prompted, by typing [y] (yes).
By completing the above procedure, this erases any user configurations made to date and restores
the CDD-56X to its factory default configuration.
Proceed to Section A.3 to perform the Router Mode configuration.
- CDD-562L/56 1
- Errata A 3
- Errata Page 2 of 6 4
- Chapter 4. FLASH UPGRADING 5
- Errata Page 4 of 6 6
- Upload Procedure 7
- Errata Page 6 of 6 8
- CDD-562L/564 9
- Table of Contents 11
- Figures 18
- PREFACE 21
- Cautions and Warnings 22
- Electrical Safety 22
- Environmental 22
- Installation 22
- Preface MN/CDD564L.IOM 23
- Warranty Policy 24
- Limitations of Warranty 24
- Exclusive Remedies 25
- Customer Support 26
- Online Customer Support 26
- Chapter 1. INTRODUCTION 27
- 1.2 Functional Description 28
- 1.3 Features 30
- 1.3.1 Physical Description 30
- 1.3.3 Major Assemblies 30
- 1.3.4 Dimensional Envelopes 31
- Introduction MN/CDD564L.IOM 32
- 1.3.5 Physical Features 33
- 1.3.5.1 Front Panel 33
- 1.3.5.2 Rear Panel 34
- 1.3.6 Data Interfaces 35
- 1.4 New in this Release 36
- 1.5.1 Demodulator 37
- LNB current and voltage 38
- 1.5.4 Network Protocols 39
- 1.5.5 BER (Bit Error Rate) 40
- Chapter 2. INSTALLATION 41
- IMPORTANT 42
- 2.4 Connect External Cables 43
- 2.3 Configuration 43
- Installation MN/CDD564L.IOM 44
- Chapter 3. REAR PANEL 45
- CONNECTOR PINOUTS 45
- CA UTION 46
- 3.5.3 Ground Connector 49
- Chapter 5. FORWARD ERROR 55
- CORRECTION 55
- Comtech Turbo Product Codec 58
- Rate 3/4 QPSK/OQPSK 58
- 8-PSK and 16-QAM 58
- Rate 7/8 QPSK/OQPSK 59
- Rate 21/44 QPSK/OQPSK 60
- Rate 0.95 QPSK/OQPSK 60
- INTERFACE OVERVIEW 61
- 6.3 Demodulator Features 63
- 6.3.2 IP Header Compression 63
- 6.3.3 Payload Compression 64
- IMPOR TANT 66
- Chapter 7. ETHERNET 73
- MANAGEMENT 73
- 7.4.3 SNMP Traps 76
- 7.4.4 MIB-II 76
- 7.4.5 Private MIB 77
- 7.4.5.1.2 Features Subgroup 77
- 7.5 Telnet Interface 81
- 7–10 82
- Chapter 8. WEB SERVER (HTTP) 83
- INTERFACE 83
- 8.2.1 “Splash” (Home) Page 85
- Maint 86
- 8.2.2 Home Pages 87
- 8.2.2.1 Home 87
- 8.2.2.3 Home 89
- 8.2.3 Admin Pages 90
- 8.2.3.1 Admin 90
- 8.2.3.2 Admin 91
- Host Access List 92
- 8.2.3.3 Admin 93
- 8.2.4.1 Demod 96
- 8.2.4.2 Demod 97
- 8.2.4.3 Demod 98
- 8.2.4.4 Demod 99
- 8.2.4.5 Demod 100
- 8.2.5 IP Pages 101
- 8.2.5.1 IP 101
- 8.2.5.2 IP 102
- 8.2.5.3 IP 104
- 8.2.5.4 IP 105
- Multicast Route Table 106
- 8.2.5.5 IP 107
- 8.2.5.6 IP 108
- VLAN Table 109
- VLAN Table – Add/Delete 109
- 8.2.5.7 IP 110
- 8.2.6 Stats Pages 111
- 8.2.6.1 Stats 111
- 8.2.6.2 Stats 112
- 8.2.6.3 Stats 113
- 8.2.7.1 Maint 114
- 8.2.7.2 Maint 115
- 8.2.7.3 Maint 116
- 8.2.7.4 Maint 117
- A.1 Introduction 119
- A.2 Getting Started 119
- A.2.1 Equipment List 119
- A.2.2 Basic Equipment Setup 120
- Appendix A MN/CDD564L.IOM 121
- A.3.1 PC Configuration 123
- A.3.4 Set IP Address(es) 125
- Appendix B. E 129
- MEASUREMENT 129
- Appendix B MN/CDD564L.IOM 130
- (Co+No/No )/10) 130
- Appendix C. FAST ACTIVATION 133
- PROCEDURE 133
- C.3.1 Record Serial Number 134
- Appendix C MN/CDD564L.IOM 135
- Purchase Access Code here 136
- 2. Click when done 136
- Appendix D. CDM/CDD NMCS 137
- PROTOCOL, REV 1.0 137
- D.3 NMCS Protocol 138
- D.3.1 Overview 138
- D.3.2 Telnet Interface 138
- D.3.3 Basic Protocol 138
- D.3.4 Command Structure 139
- D.3.4.1 Start of Packet 139
- D.3.4.2 Target Address 139
- D.3.4.3 Address Delimiter 140
- D.3.4.4 Instruction Code 140
- D.3.4.7.1 Index 141
- D.3.4.7.2 Argument Lists 142
- D.3.4.8 End of Packet 142
- D.4 Commands and Queries 143
- D.4.1.6 Redundancy Query 159
- D.4.1.8.1 Wan Stats 161
- D.4.1.8.2 IP Stats 162
- D.4.1.8.3 Ethernet Stats 164
- D.4.1.8.4 QoS Stats 165
- D.5 Param Files 166
- METRIC CONVERSIONS 171
- Units of Length 171
- Temperature Conversions 171
- Units of Weight 171
- 480 • 333 • 2200 PHONE 172
- • 333 • 2161 FAX 172
Produits connexes et manuels pour Mise en réseau Comtech EF Data Vipersat CDD-564L
(4 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.069 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels