Comtech EF Data Vipersat CDD-564L Spécifications Page 82
- Page / 172
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
CDD-562L/564 Demodulator with IP Module Revision 1
Ethernet Management MN/CDD564L.IOM
7–10
There is a disadvantage when using Windows DOS as Telnet Client. Since Windows DOS cannot
translate a ‘\r’ to a ‘\r\n’ for the messages coming from Telnet Server, the multi-line command
response (for example, FRW? response) will be displayed as one line, with the latter lines
overwriting the previous lines.
In order to view the full response messages, CEFD recommends using HyperTerminal configured
as Telnet Client. To do so, configure HyperTerminal as follows:
1. Under the HyperTerminal
Properties tab: Connect using
TCP/IP instead of COM1 or
COM2.
2. Under the Settings tab, ASCII
setup (far right): For ASCII
Sending, check "Send line
ends with line feeds".
For ASCII Receiving, check
"Append line feeds to in-
coming line ends".
The following screen capture shows an example of HyperTerminal configured as Telnet Client:
- CDD-562L/56 1
- Errata A 3
- Errata Page 2 of 6 4
- Chapter 4. FLASH UPGRADING 5
- Errata Page 4 of 6 6
- Upload Procedure 7
- Errata Page 6 of 6 8
- CDD-562L/564 9
- Table of Contents 11
- Figures 18
- PREFACE 21
- Cautions and Warnings 22
- Electrical Safety 22
- Environmental 22
- Installation 22
- Preface MN/CDD564L.IOM 23
- Warranty Policy 24
- Limitations of Warranty 24
- Exclusive Remedies 25
- Customer Support 26
- Online Customer Support 26
- Chapter 1. INTRODUCTION 27
- 1.2 Functional Description 28
- 1.3 Features 30
- 1.3.1 Physical Description 30
- 1.3.3 Major Assemblies 30
- 1.3.4 Dimensional Envelopes 31
- Introduction MN/CDD564L.IOM 32
- 1.3.5 Physical Features 33
- 1.3.5.1 Front Panel 33
- 1.3.5.2 Rear Panel 34
- 1.3.6 Data Interfaces 35
- 1.4 New in this Release 36
- 1.5.1 Demodulator 37
- LNB current and voltage 38
- 1.5.4 Network Protocols 39
- 1.5.5 BER (Bit Error Rate) 40
- Chapter 2. INSTALLATION 41
- IMPORTANT 42
- 2.4 Connect External Cables 43
- 2.3 Configuration 43
- Installation MN/CDD564L.IOM 44
- Chapter 3. REAR PANEL 45
- CONNECTOR PINOUTS 45
- CA UTION 46
- 3.5.3 Ground Connector 49
- Chapter 5. FORWARD ERROR 55
- CORRECTION 55
- Comtech Turbo Product Codec 58
- Rate 3/4 QPSK/OQPSK 58
- 8-PSK and 16-QAM 58
- Rate 7/8 QPSK/OQPSK 59
- Rate 21/44 QPSK/OQPSK 60
- Rate 0.95 QPSK/OQPSK 60
- INTERFACE OVERVIEW 61
- 6.3 Demodulator Features 63
- 6.3.2 IP Header Compression 63
- 6.3.3 Payload Compression 64
- IMPOR TANT 66
- Chapter 7. ETHERNET 73
- MANAGEMENT 73
- 7.4.3 SNMP Traps 76
- 7.4.4 MIB-II 76
- 7.4.5 Private MIB 77
- 7.4.5.1.2 Features Subgroup 77
- 7.5 Telnet Interface 81
- 7–10 82
- Chapter 8. WEB SERVER (HTTP) 83
- INTERFACE 83
- 8.2.1 “Splash” (Home) Page 85
- Maint 86
- 8.2.2 Home Pages 87
- 8.2.2.1 Home 87
- 8.2.2.3 Home 89
- 8.2.3 Admin Pages 90
- 8.2.3.1 Admin 90
- 8.2.3.2 Admin 91
- Host Access List 92
- 8.2.3.3 Admin 93
- 8.2.4.1 Demod 96
- 8.2.4.2 Demod 97
- 8.2.4.3 Demod 98
- 8.2.4.4 Demod 99
- 8.2.4.5 Demod 100
- 8.2.5 IP Pages 101
- 8.2.5.1 IP 101
- 8.2.5.2 IP 102
- 8.2.5.3 IP 104
- 8.2.5.4 IP 105
- Multicast Route Table 106
- 8.2.5.5 IP 107
- 8.2.5.6 IP 108
- VLAN Table 109
- VLAN Table – Add/Delete 109
- 8.2.5.7 IP 110
- 8.2.6 Stats Pages 111
- 8.2.6.1 Stats 111
- 8.2.6.2 Stats 112
- 8.2.6.3 Stats 113
- 8.2.7.1 Maint 114
- 8.2.7.2 Maint 115
- 8.2.7.3 Maint 116
- 8.2.7.4 Maint 117
- A.1 Introduction 119
- A.2 Getting Started 119
- A.2.1 Equipment List 119
- A.2.2 Basic Equipment Setup 120
- Appendix A MN/CDD564L.IOM 121
- A.3.1 PC Configuration 123
- A.3.4 Set IP Address(es) 125
- Appendix B. E 129
- MEASUREMENT 129
- Appendix B MN/CDD564L.IOM 130
- (Co+No/No )/10) 130
- Appendix C. FAST ACTIVATION 133
- PROCEDURE 133
- C.3.1 Record Serial Number 134
- Appendix C MN/CDD564L.IOM 135
- Purchase Access Code here 136
- 2. Click when done 136
- Appendix D. CDM/CDD NMCS 137
- PROTOCOL, REV 1.0 137
- D.3 NMCS Protocol 138
- D.3.1 Overview 138
- D.3.2 Telnet Interface 138
- D.3.3 Basic Protocol 138
- D.3.4 Command Structure 139
- D.3.4.1 Start of Packet 139
- D.3.4.2 Target Address 139
- D.3.4.3 Address Delimiter 140
- D.3.4.4 Instruction Code 140
- D.3.4.7.1 Index 141
- D.3.4.7.2 Argument Lists 142
- D.3.4.8 End of Packet 142
- D.4 Commands and Queries 143
- D.4.1.6 Redundancy Query 159
- D.4.1.8.1 Wan Stats 161
- D.4.1.8.2 IP Stats 162
- D.4.1.8.3 Ethernet Stats 164
- D.4.1.8.4 QoS Stats 165
- D.5 Param Files 166
- METRIC CONVERSIONS 171
- Units of Length 171
- Temperature Conversions 171
- Units of Weight 171
- 480 • 333 • 2200 PHONE 172
- • 333 • 2161 FAX 172
Produits connexes et manuels pour Mise en réseau Comtech EF Data Vipersat CDD-564L
(4 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.041 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels