Comtech-ef-data NetVue Release 1.1 User Guide Manuel d'utilisateur Page 94

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 265
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 93
Protocols Revision 3
NetVue User Guide MN-NETVUE
4–11
4. Enter a Name for the element.
5. Select a
Protocol. In this example, the NetPerformer protocol is selected.
6. Make sure the
Version is the correct driver version.
7. Enter the
IP address of the device.
Figure 4-11 New Element configuration
8. Confirm all the information is correct and then click Create near the bottom-right corner
4.2.7 Removing a Microsoft Visio VDX file from a protocol
1. In the Protocol list section, select the protocol.
2. At the bottom of the section, click
Remove vdx.
4.2.8 Creating an information overlay
1. In the Protocol list section, open the Information node of a protocol and select Default Information.
2. In the bottom-right corner of the
Information tab, click Save as.
3. Enter the name of the new overlay file and click
Save.
4. In the
Protocol list section, select the newly created overlay file.
5. In the
Information tab, make the necessary changes, and click Save.
Vue de la page 93
1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 264 265

Commentaires sur ces manuels

Pas de commentaire